* Sea-Bird  Data File:
* FileName = C:\Data\CMI\Barabara\011005\barab0105058.hex
* Software Version 1.43
* Temperature SN =  4141
* Conductivity SN =  4141
* System UpLoad Time = Jan 21 2005 11:07:53
* ds
* SeacatPlus V 1.3a  SERIAL NO. 4141    21 Jan 2005  12:09:37
* vbatt = 12.4, vlith =  8.3, ioper =  62.2 ma, ipump =  93.3 ma, 
* iext01 =  74.7 ma, iext23 =   3.9 ma, 
* status = not logging
* number of scans to average = 1
* samples = 143404, free = 298101, casts = 65
* mode = profile, minimum cond freq = 3167, pump delay = 40 sec
* ignore magnetic switch = no
* battery type = ALKALINE, battery cutoff =  7.5 volts
* pressure sensor = strain gauge, range = 508.0
* SBE 38 = no, Gas Tension Device = no
* Ext Volt 0 = yes, Ext Volt 1 = yes, Ext Volt 2 = yes, Ext Volt 3 = yes
* echo commands = yes
* output format = raw HEX
* S>
* 
* SeacatPlus V 1.3a  SERIAL NO. 4141    21 Jan 2005  12:09:58
* temperature:  18-feb-04
*     TA0 = 1.231057e-03
*     TA1 = 2.751917e-04
*     TA2 = -2.342421e-06
*     TA3 = 2.469670e-07
*     TOFFSET = 0.000000e+00
* conductivity:  18-feb-04
*     G = -1.005036e+00
*     H = 1.414952e-01
*     I = -6.767237e-04
*     J = 7.041491e-05
*     CF0 = 2.677689e+03
*     CPCOR = -9.570000e-08
*     CTCOR = 3.250000e-06
*     CSLOPE = 1.000000e+00
* pressure S/N = 194, range = 508 psia:  10-feb-04
*     PA0 = 9.823803e-03
*     PA1 = 1.544767e-03
*     PA2 = 6.010935e-12
*     PTCA0 = 5.243490e+05
*     PTCA1 = 7.231049e-02
*     PTCA2 = 4.341443e-03
*     PTCB0 = 2.509750e+01
*     PTCB1 = -9.000000e-04
*     PTCB2 = 0.000000e+00
*     PTEMPA0 = -5.839876e+01
*     PTEMPA1 = 5.388513e+01
*     PTEMPA2 = -3.376079e-01
*     POFFSET = 0.000000e+00
* volt 0: offset = -4.762667e-02, slope = 1.251779e+00
* volt 1: offset = -4.762667e-02, slope = 1.250671e+00
* volt 2: offset = -4.803000e-02, slope = 1.250671e+00
* volt 3: offset = 0.000000e+00, slope = 1.000000e+00
*     EXTFREQSF = 9.999936e-01
* dh
* cast  58 10 Jan 2005 11:32:57 samples 125008 to 125949, avg = 1, stop = mag switch
* S> 
# nquan = 10
# nvalues = 742                         
# units = specified
# name 0 = prdM: Pressure, Strain Gauge [db]
# name 1 = tv290C: Temperature [ITS-90, deg C]
# name 2 = v0: Voltage 0
# name 3 = v1: Voltage 1
# name 4 = par: PAR/Irradiance, Biospherical/Licor
# name 5 = depSM: Depth [salt water, m], lat = 59
# name 6 = sigma-é00: Density [sigma-theta, Kg/m^3]
# name 7 = sal00: Salinity [PSU]
# name 8 = sbeox0Mg/L: Oxygen, SBE 43 [mg/l], WS = 2
# name 9 = sbeox0PS: Oxygen, SBE 43 [% saturation], WS = 2
# span 0 =     -0.120,     25.615       
# span 1 =     3.8115,     4.7831       
# span 2 =     0.2258,     0.6046       
# span 3 =     0.1288,     4.2240       
# span 4 = 9.1622e-02, 3.0947e+01       
# span 5 =     -0.119,     25.374       
# span 6 =    14.7200,    25.1246       
# span 7 =    18.5369,    31.6454       
# span 8 =    5.82990,    7.52055      
# span 9 =   54.34901,   70.08957      
# interval = seconds: 0.25                        
# start_time = Jan 10 2005 11:32:57
# bad_flag = -9.990e-29
# sensor 0 = Frequency 0  temperature, 4141, 18-Feb-04
# sensor 1 = Frequency 1  conductivity, 4141, 18-Feb-04, cpcor = -9.5700e-08
# sensor 2 = Pressure Number
# sensor 3 = Extrnl Volt  0  WET Labs, WETStar fluorometer, WS3S-781P, 12 Sep 01
# sensor 4 = Extrnl Volt  1  transmissometer, primary, unknown, unknown
# sensor 5 = Extrnl Volt  2  Oxygen, SBE, primary, 0332, 10/1/02
# sensor 6 = Extrnl Volt  3  irradiance (PAR), primary, 6246, 7/19/01
# datcnv_date = Jan 23 2005 22:12:13, 5.31a
# datcnv_in = C:\Data\CMI\Barabara\011005\barab0105058.hex C:\Data\CMI\4141cmi04.con
# datcnv_skipover = 200
# filter_date = Jan 23 2005 22:14:42, 5.31a
# filter_in = C:\Data\CMI\Barabara\011005\barab0105058.cnv
# filter_low_pass_tc_A = 0.030
# filter_low_pass_tc_B = 0.150
# filter_low_pass_A_vars = c0mS/cm
# filter_low_pass_B_vars =
# alignctd_date = Jan 23 2005 22:16:16, 5.31a
# alignctd_in = C:\Data\CMI\Barabara\011005\barab0105058.cnv
# alignctd_adv = tv290C 0.400, sbeox0V 4.000, v1 3.000                                                                                                                                                                               
# Derive_date = Jan 23 2005 22:19:02, 5.31a
# Derive_in = C:\Data\CMI\Barabara\011005\barab0105058.cnv C:\Data\CTD\cmi0304\4141cmi04.con
# derive_time_window_docdt = seconds: 2
# file_type = ascii
*END*