Information on CTD raw data observed by R/V MIRAI (Cruise number : MR99-K07) 1. Preface ---------- CTD(Conductivity-Temperature-Depth profiler) is used to observe the vertical profiles of temperature and conductivity. Usually, this system is operated with multicylinder water sampler. Observed signal is transmitted from sensor to the operation room on board using wire cable, and electric power is supplied from vessel to sensor. Details of sensors attached to CTD system for MR99-K07 cruise are presented in section 3. The following software, developed and supplied by the Sea-Bird Electronics, Inc., was used in MR99-K07. SEASAVE(ver 4.232) for data acquisition SEASOFT(ver 4.232) for data processing Data presented on this website is averaged over 1m. 2. CTD sampling system ---------------------- Following is the option for CTD/RMS(Rosette Multi Sampler) system; CTD/RMS and 24 Niskin bottles of 30L 3. Sensors ---------- (1) Temperature sensor Model : SBE3-04F, Sea-Bird Electronics,Inc. Serial number : 031524 Measurement range : -5.0 to +35degC Accuracy : 0.001degC Resolution : 0.0002degC (2) Salinity sensor Model : SBE4-04/O, Sea-Bird Electronics,Inc. Serial number : 041202 Measurement range : 0.0 to 7S/m Accuracy : 0.0003S/m Resolution : 0.00004S/m (3) Pressure sensor Model : SBE9plus, Sea-Bird Electronics,Inc. Serial number : 0280 Measurement range : up to 10500m Accuracy : 0.015%F.S. Resolution : 0.001%F.S. (4) Altimeter Model : Benthos 2110-1, Serial number : 0206 (5) Fluorometer Model : Seapoint Sensors,Inc. Serial number : 2148 4. Notes -------- (1) Data processing sequence for SEASOFT as follows; -------------------------------------------------------------------- command function -------- ---------------------------------------------------------- datcnv Convert raw data to engineering units, and store converted data in file. section Extract rows of data from file. wildedit Mark a data value with badflag to eliminate wild points. binavg Average data, basing bins on pressure, depth, scan number, or time range. split Split data in file into upcast and downcast files. --------------------------------------------------------------------